1/5/2024 0 Comments Extractor socket setRemembered that I had the Grab-Its, use one and it pulled the screw no problem. I used one to pull a 4" screw out of a palette coffee table I made.that screw wouldn't come out no matter what I did and I did everything. The few times I've used them they've worked great, haven't broken, haven't stripped. To be completely honest, I love those too. I also have a set of those "seen-on-tv" type, mine are "Grab-It". I haven't used the ones with the 1/4" shank very much, but the few times I have I haven't had any problems with the shank breaking or twisting, but I don't know how eager I'd be to really crank down on them in an impact or drill.Īfter many many years of using the typical drill/extractor type and having them break I would never go back to them, the Irwins are my go-to for any stubborn nut or bolt. I use them enough both at work and at home to trust them and go to them any time I need to free a stubborn nut or bolt. So far the times we've used them at work they haven't failed, and I have yet to see any of my personal extractors fail. I just toss the bad one and replace it with a good one from another set and all is good. I see them getting returned at work often, normally it's because one of them was stripped, the "teeth" somehow were smoothed-out, like the bolt trying to be removed was harder than the extractor material. So far I haven't broke one, and none have failed to pull even the nastiest of frozen/stripped bolt or nut. I have a few of the different types at home, made by Irwin, and I use them a lot and love them. For something that would likely get thumped into place with a hammer, and cranked on.also good. I do not know if that is a good thing or not. Yay or nay? The HF is an inexpensive set. Some might say that answers the question I am curious if anyone has any of these, or other common examples (Irwin, Proto, Hansen). For example, a set like the ones HF sells:Īre these worth having as a "just in case" measure? Or are they generally a waste of money? Like I said, I've used my Cmans ONCE. I actually really like those, but I digress.Īre the socket forms of extractors worth having on hand? Rounded fasteners are kind of the bane of a mechanic's existence. I know there are a few options in terms of extractors. It was nice to have, as nothing else would have worked aside from cutting off the head (carefully, as this was a coil pack on a car). Ones that can be chucked up in a drill, and ones that can be turned with a socket or wrench.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |